Types of Ring locks

Read more Go to product Read more Products class="post-40 page type-page status-publish has-post-thumbnail hentry"

Euroring specialises in various types of locks, tailored completely according to the application and the required use. Below you’ll find several possible options that are among the most commonly used. There are many more options that may apply to your specific situation that aren’t listed here. For more information please do not hesitate to contact us.

Type A / Butt joint

The butt joint version of the piston ring is the standard type. This is most common in combustion engines with...
Type B / Angle cut

The angle lock is often used when the piston ring is running over in- and outlet gates used in hydraulic applications....
Type C / Radial cut

Just like the angled lock, this lock type in piston rings is also marked with a left and right type. For optimum...
Type D / Step cut

As with the angled lock, the ends are less likely to hang in a coil or control port during linear movements. In...
Type E / Gastight cut

Due to the geometry of this type of lock, optimum sealing is possible. This type of lock is retained under varying...
Type F / Lock step cut

This lock type is mainly used to prevent the piston ring from springing open during installation. The preload creates...
Type G / Inside notch cut

This type of lock is used just as the side lock, to prevent rotation of the piston ring in the groove. If this type of...
Type H / Side notch cut

This type of lock is used, just like the inner lock, to lock the rotation of the piston ring in the groove. Access from...
Type I / Dual gastight cut

The design of this gastight piston ring is aimed at providing maximum efficiency in conditions that involve, for...
Type J / Radial step cut

This type of lock is similar to the step/lock step cut in terms of its design, except rotated by 90 degrees. This type...